Renovation ready
Fits straight over the existing hole.
Most Australian homes were prepared with a 54mm cutout. Our lever handles sit on a 63mm rose, which covers it completely. That means an existing door can take new hardware without patching, filling or a coat of paint, and without replacing a single door.
The existing hole
54mm
The standard door preparation used across Australian homes for decades.
Our rose
63mm
Covers the existing cutout completely. No patching, no filler, no repaint.
No new doors
The existing door stays. Our levers mount straight over the old cutout, so a renovation does not turn into a joinery job.
No patching or painting
Nothing to fill, sand or touch up. The rose covers the hole, and the door is finished the moment the handle is on.
Either backset covered
Ours suit the 60mm Australian standard. If your doors are set out at 70mm, we supply the correct latch to match, so the door still works.
Lever handles
The Long
A 138mm lever on a 63mm rose. The longest lever in the range and the easiest to live with, particularly for older hands. Fits straight over a 54mm cutout.
Lever handles
The Curve
A softly curved 130mm lever on the same 63mm rose. Warmer in the hand than an angular profile, and just as forgiving on an existing door.
Sliding and cavity doors
Flush pulls
Oval and rectangular flush pulls for sliding and cavity doors. A straightforward swap where an existing pull has dated or worn, and available in all four finishes to match the levers.
Before you order
Check the door first.
Measure the diameter of the existing hole in the door face. If it is 54mm or smaller, our levers will cover it.
Then check the backset, the distance from the edge of the door to the centre of the hole. Ours suit 60mm, which is the Australian standard. If your doors are set out at 70mm, tell us and we will supply the correct latch to suit, so the handle still fits and the door still latches properly.
If the existing hole is larger than 54mm, or the door has been previously modified, send us a photograph and a measurement and we will tell you honestly whether it will work.
Not sure it will fit?
Send us a photo and a measurement.
We will tell you whether our hardware suits your existing doors before you order anything, and make sure the right latch goes with it.